The second fill used the Right Mouse button so the Secondary color was used (green). The first fill used the Left Mouse button, resulting in a fill in the Primary color (gray). The Paint Bucket was applied three times: once inside each shape, and once in the overlapping region. In the example shown below, two shapes were drawn. The fill will be applied in accordance with the other parameters ( Tolerance, Sampling Mode, Fill Style, etc.) then reinterpreted as if the pixels were on their own layer with the layer blend mode set. The Paint Bucket can be applied using a blend mode selected from the Tool Bar. The Tolerance Alpha Mode toggle button is common to the Magic Wand, Paint Bucket, and Recolor tools. Straight results in transparent pixels being treated as equal only if the color channel values are also equal. Premultiplied results in transparent pixels being treated as equal even if the color channels are different. The states are Premultiplied (default) and Straight. This toggle button changes the algorithm which determines how the alpha channel contributes to the comparison of neighboring pixels. This is the same sampling mode as found in previous versions of. Layer - pixels only within the active layer and selection (if any) are polled to determine their suitability to be included in the fill operation. Pixels outside an active selection will be ignored and only pixels within the active layer will be subject to the fill. This mode will operate in the same way as if a multi-layered image was flattened prior to using the Paint Bucket tool. Image - pixels are polled from the composite image to determine their suitability to be included in the fill operation. The Sampling Modes dictate which pixels will be sampled or tested to determine the extent of the fill operation. These modes are shared by the Paint Bucket, Magic Wand Tool and Color Picker tools (shown below). The Paint Bucket has two sampling modes, Image and Layer. This feature allows regions to be filled with one of numerous patterns rather than a solid color.įills utilizing a fill style will make use of both the Primary and Secondary colors. The Paint Bucket will fill a region with a Fill Type as specified in the Tool Bar. The fill operation will be reinterpreted as if the user had undone the original fill and reapplied it using the new source point.Ĭlick the Finish button in the Tool Bar or press Enter to commit the fill to the layer. New to is the ability to adjust the click point of the Paint Bucket Tool while the fill is still 'active' and not 'finished'.Ĭlick and drag the Control nub to relocate the click point. The action of dragging the click point is shown in the animation below. The left hand image shows the relocated click point and the resultant changed fill. As the fill operation no longer applies to the left gear, it reverts to it's pre-filled color (yellow). It is easy to apply this fill to a different gear simply drag the click point over the region to be filled. The image above shows an initial fill operation has colored the left gear pink. The fill operation will be reinterpreted as if the user had undone the original and reapplied it using the new source point. The Control Nub looks like a white square with four arrows inside it (see image below).Ĭlick and drag this icon to relocate the click point. This replaces the need to undo and reapply the fill operation to a different region. New to 4 is the ability to adjust the click point of the Paint Bucket Tool while a fill is still active. New to 4 is the ability to change the color of a fill while it is still 'active' and not 'finished'.Īltering the fill color in the Colors window immediately recolors the filled region.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |